Canyon CN-WF518 Manuel d'utilisateur

CNP-WF518 Wireless USB Adapter User Manual

z Show Tray Icon: Show USB Wireless LAN Utility icon in Windows Notification Area. z Disable Adapter: Disable the wireless adapter. z Radio off: Tu

Add: 1. Creating a new Infrastructure mode profile 1. Type in Profile Name (user defined) and SSID(actual network name from wireless router). 2. S

Remove: Select a profile and click on Remove to delete it. Edit: Select a profile and click on Edit to modify it. Please refer to Add section for mor

3. Available Network The Available Network tab displays a list of infrastructure and AD-HOC networks available for wireless connection. 1. Select a

4. Advanced The Advanced tab displays a number of advanced options. 1. Power Save: Select the frequency of message response time. 2. Turbo Mode: E

5. Status The Status tab displays the detailed information of current device and wireless connection.

6. Statistics The Statistics tab displays the values of current wireless connection Tx and Rx. Click on Reset button to reset values and to renew to

7. Wi-Fi Protected Setup (WPS) The Wi-Fi Protected Setup tab provides an easier means to join existing wireless network. Pin Input Config (PIN): Cli

Troubleshooting Please refer to the following procedures if CNP-WF518 does not function as it should be. Be advised that the following instructions a

Appendix Technical Specifications Standards IEEE 802.11g, IEEE802.11b Channels 13 Channels Interface USB Port Network Protocol TCP/IP, IPX, ND

Table of Contents INTRODUCTION...

Thank you for purchasing CANYON CNP-WF518. We sincerely wish you to enjoy the 802.11b/g wireless network adapter. It is an easy-to-install device that

Package Contents Product Image Item Name CNP-WF518 Main Unit Warranty Card Quick Guide Driver CD Hardware Overview USB Connector Connects to P

Getting Started Before using CANYON CNP-WF518, please make sure that the PC and the device are within range of an access point (802.11b, 802.11g, or

4. Select preferred setup language. 5. Click on Next to continue or Cancel to exit. 6. Click Next again at InstallShield Wizard page or Cancel to e

2. The Utility main page will be displayed as shown. 3. To setup basic wireless network with existing access point or wire- less router, click on S

8. Review wireless network settings. 9. Enter Passphrase (WEP) or Network Key (WPA/WPA2) if required. 10. Click on Ok to continue or Cancel to exit

1. General The General tab displays current wireless connection information. Click on ReNew IP to release and renew IP address. General Information: